-
多层特性阻抗板的一些加工要求
发布时间:2023-06-05 | 信息来源:遇见电路(深圳)有限公司阻抗值的计算方式一般都是这样的:8.0(98.5ln41.1/870TWHZr),所在的层不同、类型不同,他们的的阻抗所采用的具体公式有所区别,但是影响特性阻抗值的主要因素有:
介质常数:取决于加工线路板使用的材料,FR-4材料的介电常数一般为:4.5~4.9之间,生产厂商计算一般采用为4.5。
介质厚度:指的是控制该阻抗值的信号层对指定参考层的之间介质厚度。
导线宽度、导线间距:单端阻抗线只需注明哪一层、哪种线进行阻抗控制;差分阻抗线除了注明前两个参数外,还需注明两个信号线之间的固定间距;
导线厚度:取决于控制阻抗线是属于内层还是外层
1、相对于内层而言:当最小线宽和最小间距>5mil时内层线路的成品铜箔厚:33μm;当最小线宽和最小间距≤5mil时内层线路的成品铜箔厚:15μm;
2、相对于外层而言:当最小线宽≥10mil,最小间距≥8mil时成品线路的铜箔厚为:70μm;当最小线宽<10mil,最小间距<8mil时成品线路的铜箔厚为:40μm。
以上内容由PCB阻抗板打样厂家遇见电路小编整理于网络分享,希望通过本文的介绍能帮助到大家。下一篇:什么是电路板快速打样相关资讯